Power Semiconductors and Power Modules for X-ray Inspection Application X-ray inspection is essential for power semiconductors and power modules in production quality control and analysis. The semiconductor chips (dies) made of Silicon Carbide (SiC) or Gallium Nitride[...] Aluminum Casting Defect in X-ray Inspection Application In aluminum die casting and other metal casting processes, Cavities may occur inside metal casting parts. The cavities created in casting and die casting are called "Shrinkage Cavities", "Gas P[...] Cap and Neck Finish X-ray inspection For Cap and Neck Finish inspection, we recommend the horizontal models of the X-ray inspection systems with Computed Tomography (CT) scan. A liquid bottle can be set upright with the horizontal [...] Industrial heater X-ray inspection Industrial heaters include sheathed heaters, panel heaters, ribbon heaters, hot plates, and cartridge heaters. The heater generates heat due to its resistance when the resistance wire (resistance[...] Automotive parts X-ray inspection High quality, safety, and reliability are strongly required for in-vehicle parts. X-ray inspection systems are used in full or frequent sampling inspections of the in-vehicle parts. X-ray inspect[...] Lithium Ion Battery (LIB) for X-ray Inspection Application Lithium-ion batteries (LIB, LFP, NMC) consist of alternating layers of cathode plates, anode plates, and separators inside a case. X-ray inspection systems are used to inspect the quality[...] Aluminum Electrolytic Capacitor for X-ray Inspection Application Quality inspections are crucial because internal faults like miswindings of the film inside electrolytic capacitors can cause fires. Electrolytic capacitor cannot be visually inspected once it has[...] Multi-conductor (multicore) cable disconnection X-ray inspection X-ray inspection is used to inspect the inside of the cables. Some electrically conductive cables may not conduct electricity because of the position or bending condition. In some cases, if wires[...] Insert molding (Injection molding) parts X-ray inspection Insert molding is a method of integrally molding metal parts such as terminals by using resin or rubber. Insert molded products may look normal from the outside, but metal-to-metal contact may c[...] Wire harness X-ray inspection In X-ray inspection of connectors and harnesses, molded connectors, crimped and press-fit parts, soldered parts, wires, and shielded wires are inspected to detect defects such as breaks and short[...] 1 2 NEXT
